An early SpaceX engineer crawled inside an imploding rocket on a jet in midair to save the company

An early SpaceX engineer crawled inside an imploding rocket on a jet in midair to save the company
Elon Musk.Britta Pedersen-Pool/Getty Images
  • SpaceX almost ran out of money in 2008 and had one last chance to launch a rocket to orbit.
  • Its one remaining rocket began to implode while flying on board a C-17 jet, according to a new book.
  • So engineer Zach Dunn crawled inside the rocket to stop its collapse and save SpaceX.

SpaceX almost died aboard a C-17 jet above Hawaii.

In 2008, before the company had successfully launched a single rocket, two dozen SpaceX engineers were transporting its Falcon 1 rocket to Hawaii inside an Air Force jet. From there, a barge would carry it to the company's launch facilities in the Marshall Islands for one more launch attempt. It was the company's last chance: If this failed, SpaceX would be done for.

An early SpaceX engineer crawled inside an imploding rocket on a jet in midair to save the company
HarperCollins Publishers

But as the jet descended ahead of landing, the SpaceXers heard "a loud, terrible, popping noise," according to a new book by Eric Berger, a journalist and senior space editor for Ars Technica. The rocket was imploding because of a pressure imbalance. So Zach Dunn, one of SpaceX's newest engineers at the time, crawled into its belly. His quick fix saved the company - and possibly his own life.

Berger's book "Liftoff" describes this moment and other wild events from SpaceX's early years - including the construction of a launchpad on a remote island, a mutiny staged by engineers trapped on that island without food, and the scramble to send a commercial rocket into orbit.

SpaceX finally reached orbit using the very rocket that nearly crumpled in midair.


SpaceX engineers faced a midflight emergency

By September 2008, SpaceX was almost out of money, according to Berger's book. The company had failed in all of its attempts to launch a rocket into orbit, so it wasn't winning any contracts. Musk was running out of cash to pump into SpaceX and Tesla, which were both floundering as the recession hit. SpaceX had enough resources for just one more launch attempt, the book said.

Musk gave his engineers six weeks for the last-ditch effort, Berger wrote. When they were ready to transport the Falcon 1 rocket from California to the Marshall Islands, the engineers piled into the C-17 jet at Los Angeles International Airport. For the first few hours of the flight to Hawaii, they cruised smoothly above the Pacific, kicking back in cargo-compartment seats surrounding the rocket. Someone broke out a guitar, according to the book.

But on the descent, loud pops and pings rang through the cargo area as dents appeared along the rocket's body. The engineers realized that its liquid-oxygen fuel tank was not venting enough air to keep up with the changes in pressure as the jet descended.

The tank was basically "breathing through a straw," Berger wrote.

As the pressure in the jet's cargo bay increased relative to the pressure inside the rocket's fuel tank, the Falcon 1 started to crumple.


"The first thought I had was that this thing is going to implode and rebound," Anne Chinnery, who was managing SpaceX launch operations at the time, told Berger. "And it would kill all of us who were sitting next to the rocket in the airplane jump seats. So I hopped up and told everybody to get to the front of the rocket."

Dunn, who'd joined SpaceX as an intern in 2006 and quickly ascended to become a propulsion engineer, was about to save the rocket, its engineers, and SpaceX itself.

In the belly of the beast

An early SpaceX engineer crawled inside an imploding rocket on a jet in midair to save the company
Zach Dunn, a former senior engineer at SpaceX, now works for the 3D-printed rocket startup Relativity Space.Zachary Dunn/Relativity Space
An engineer asked the jet pilots to fly the plane higher, where air pressure was lower. But the pilots had enough fuel to circle the base only once more before landing. According to Berger, that bought the SpaceX engineers about 10 minutes.

They sliced open the shrink wrap enveloping the rocket and found the C-17's onboard tool kit.

Dunn told engineer Mike Sheehan to hold his ankles and yank him out if the rocket started to explode, according to the book. He wiggled into the Falcon 1's interstage - the section between the bulky base of the rocket, which propels it through the air, and the smaller section that continues into orbit.

In the darkness of the Falcon 1's belly, Dunn crawled toward the liquid-oxygen tank, sharp rocket parts scraping his back. He reached a large pressurization line to the fuel tank, twisted it open with a wrench, and heard the hiss of air flowing in, according to the book. Then he called for Sheehan to help him out.


"Sheenhan took this as a cry for help, yanking Dunn out of the interstage across the tangle of pressurization lines and valves," Berger wrote. "It hurt like hell, but Dunn emerged to find his efforts paying off."

The SpaceXers went back to their seats, and the rocket reinflated before them as the jet descended to Hawaii.

The rocket launch that saved SpaceX

Though it survived the flight, the Falcon 1 was damaged from its brush with implosion. With just a week to spare, Berger wrote the SpaceX team rushed to dismantle it, replace broken parts, repair others, and reassemble the rocket.

An early SpaceX engineer crawled inside an imploding rocket on a jet in midair to save the company
The Falcon 1 rocket.SpaceX

Then on September 28, the Falcon 1 roared to life on Omelek Island, hauled itself off the ground, and soared into orbit.

In the control room, the team members "just exploded," Dunn told Berger. "We went absolutely wild. We were all jumping around. Hugging each other. Screaming. It was a righteous celebration," he added.


SpaceX had proved its rockets could get off the planet. Afterward, the company scraped together enough contracts to keep funding flowing.

Dunn stayed at SpaceX for another decade, eventually becoming senior vice president of production and launch. Last year, he left SpaceX to oversee manufacturing at Relativity Space, a startup that hopes to automate the rocket-production process with 3D printing.